DUMB computer question :can I put DDR400 ram in a MB that wants DDR266?

emulatorloo

(1000+ posts) Send PM | Profile | Ignore

Sat Mar-04-06 11:15 AM
Original message

DUMB computer question :can I put DDR400 ram in a MB that wants DDR266?

I understand that I won't get DDR400 performance out of it. . .but I have an older Athlon Socket A motherboard that is spec'd for DDR266 Ram. I want to upgrade RAM, but figure it would make more sense to buy DDR400 ram that I could then take to my next system when I upgrade to a new motherboard in the future.

Will that work ok, or should I just buy a stick of DDR266 and shut up about it?

Sorry to be so dumb.

THANKS!

Printer Friendly | Permalink | | Top

Benfea

(1000+ posts) Send PM | Profile | Ignore

Sat Mar-04-06 11:17 AM
Response to Original message

1. Read your mobo manual

If the manual was written before PC3200 (DDR400) was available, then contact your mobo manufacturer.

Chances are, the answer is "no," but it can't hurt to check.

Printer Friendly | Permalink | | Top

emulatorloo

(1000+ posts) Send PM | Profile | Ignore

Sat Mar-04-06 11:38 AM
Response to Reply #1

2. Thank You --- I had no clue where to start (obviously!)

Anyway -- I hit thier website, and DDR400 is a no go. . .

Thanks again. :toast:

Printer Friendly | Permalink | | Top

Benfea

(1000+ posts) Send PM | Profile | Ignore

Sat Mar-04-06 11:44 AM
Response to Reply #2

3. Good luck!

It's so much more satisfying to build and upgrade on your own!

PS — why are you buying new RAM? Do you just want more, or did you have chips go bad on you? If you had chips go bad, you may want to check out your power supply and make sure it's kosher. Also, when you get your new RAM, make absolutely certain you run a RAM testing program of some sort for an hour or so after installing (the cache can mask physical problems).

Printer Friendly | Permalink | | Top

DS1

(1000+ posts) Send PM | Profile | Ignore

Sat Mar-04-06 12:06 PM
Response to Original message

4. go back to the MBs website, see if there's a BIOS flash that will

support it.

I had a SocketA chip, and the Asus board ended up support clock speeds much faster than when I bought it due to BIOS updates

Printer Friendly | Permalink | | Top

emulatorloo

(1000+ posts) Send PM | Profile | Ignore

Sat Mar-04-06 05:25 PM
Response to Reply #4

5. Great Idea! -- sadly no luck though - latest bios doesn't change it

although I learned a lot digging around the website.

Thanks!

Printer Friendly | Permalink | | Top

billyskank

(1000+ posts) Send PM | Profile | Ignore

Sat Mar-04-06 05:32 PM
Response to Original message

6. Yes. It'll just work at the lower speed

Printer Friendly | Permalink | | Top

DU AdBot (1000+ posts)

Sat May 04th 2024, 04:29 PM
Response to Original message

Advertisements [?]

Top

Powered by DCForum+ Version 1.1 Copyright 1997-2002 DCScripts.com
Software has been extensively modified by the DU administrators

Important Notices: By participating on this discussion board, visitors agree to abide by the rules outlined on our Rules page. Messages posted on the Democratic Underground Discussion Forums are the opinions of the individuals who post them, and do not necessarily represent the opinions of Democratic Underground, LLC.