ABS cement on PVC? - Democratic Underground

Kali

(1000+ posts) Send PM | Profile | Ignore

Fri Nov-09-07 03:28 PM
Original message

ABS cement on PVC?

Argh. Found the fittings I need so I don't have to drive 20 miles to town for a 79 cent coupling, but all I can find is ABS glue.

Can I use it for a pretty low pressure situation on pvc? Any other ideas?

Refresh | 0 Recommendations

Printer Friendly | Permalink | Reply | Top

Kolesar

(1000+ posts) Send PM | Profile | Ignore

Fri Nov-09-07 05:04 PM
Response to Original message

1. Epoxy

My West Systems / Gudgeon literature for marine epoxy said that epoxy is good for PVC.

Printer Friendly | Permalink | Reply | Top

Kali

(1000+ posts) Send PM | Profile | Ignore

Fri Nov-09-07 05:10 PM
Response to Reply #1

2. all I have is putty epoxy and it is too thick

used up all the jb weld. guess it's off to town. guess it'll be junk food night too! gotta combine errands. heh

Printer Friendly | Permalink | Reply | Top

Whoa_Nelly

(1000+ posts) Send PM | Profile | Ignore

Sat Nov-10-07 03:50 PM
Response to Original message

3. CHeck out this site (if only to add to bookmarks)

http://www.thistothat.com

Printer Friendly | Permalink | Reply | Top

DU AdBot (1000+ posts)

Fri May 03rd 2024, 02:07 AM
Response to Original message

Advertisements [?]

Top

Powered by DCForum+ Version 1.1 Copyright 1997-2002 DCScripts.com
Software has been extensively modified by the DU administrators

Important Notices: By participating on this discussion board, visitors agree to abide by the rules outlined on our Rules page. Messages posted on the Democratic Underground Discussion Forums are the opinions of the individuals who post them, and do not necessarily represent the opinions of Democratic Underground, LLC.